The Powder Toy

TSNS Laser Heater with 9 presets by Amphealy

Amphealy
Amphealy
114 / 7
19th Nov 2012
29th Nov 2012
Uses TSNS to manage a small URAN/BOYL reactor. The reactor then heats a PHOT beam to desired temperature. 9 temperature preset selection +/-100c accuracy. Quite slow to adjust. Work in progress
reactor control temperature aray portal phot electronics heat laser uran

Comments

  • Amphealy
    Amphealy     26th Nov 2012
    I'm not sure, maybe 4-5 hours each day over the last week.give or take a few hours.
  • Arcvain
    Arcvain     26th Nov 2012
    how long did it take you to make that
  • Amphealy
    Amphealy     25th Nov 2012
    Do you have any idea how hard it would be to cool the electronics and isolate them from the heat of the reactor and beam. It'd be more effort than it's worth.
  • cyberdragon442
    cyberdragon442     25th Nov 2012
    Wait...A HEAT LASER THAT OVERHEATS! 0_0...-_-
  • Amphealy
    Amphealy     25th Nov 2012
    turn off ambient heat
  • cyberdragon442
    cyberdragon442     25th Nov 2012
    It cuaght fire! 0_0
  • TheElectricSalad
    TheElectricSalad     25th Nov 2012
    this is amazing!
  • Amphealy
    Amphealy     24th Nov 2012
    I checked it over and can't see anyway the ETRD is getting sparked. Temperatures above 5k are not yet configured and I have no time to finish it right now. I will finish the remaining temperatures in a few hours..
  • Amphealy
    Amphealy     24th Nov 2012
    i'll check it out in a few minutes. I'm just finishing some tuning on the DLAY to stop the reactor over/under running temperatures.
  • Amphealy
    Amphealy     24th Nov 2012
    ETRD is getting sparked?