The Powder Toy

Pressure Detector by Amphealy

Amphealy
Amphealy
60 / 5
3rd Dec 2012
5th Dec 2012
Uses DSTW to detect low pressure.
youjustlost electronic detector pressure dstw logicgates involved

Comments

  • Amphealy
    Amphealy     4th Dec 2012
    @DoritosTaco, Not sure why that is. I don't think there's anything exponential going on. No idea really.
  • Dorito_tRF
    Dorito_tRF     4th Dec 2012
    the left side is a little slow, the right side is a little fast
  • Amphealy
    Amphealy     4th Dec 2012
    It's not invisible. It's just very faint due to only having a single particle and it's getting blurred into the deactivated HSWC. I tend to only ever run in nothing display (press 8) to avoid the blur. Not a fan of it, plus my computer is absolutely terrible. So it helps with FPS.
  • Cookster997
    Cookster997     4th Dec 2012
    How did you get the steam to be invisible?
  • Amphealy
    Amphealy     4th Dec 2012
    BIZR vaporization temperature doesn;t change with pressure. So, DSTW will have to do.
  • Amphealy
    Amphealy     3rd Dec 2012
    @kd2bwz. Make sure ambient heat is off from the start. even 1 or 2 degree change in DSTW will mess the save up. Also it is prone to innacuracy. I might see if BIZR has better results than DSTW. Think it should allow for lower pressure detection than DSTW.
  • Amphealy
    Amphealy     3rd Dec 2012
    @jacob1 I'll put a sign in for DECO to be turned on. Have done that a fair few times myself with other saves.
  • kd2bwz
    kd2bwz     3rd Dec 2012
    i sparked a 10 and the detector showed a 05.
  • jacob1
    jacob1     3rd Dec 2012
    no, I was adding the pressure myself with AIR actually. Then the 0 one was on all the time. I didn't know what the things on the right were, because deco was off and I sawa no numbers anywhere.
  • Amphealy
    Amphealy     3rd Dec 2012
    Oh, that one. I wasn't quite sure what you meant. That should only be on if the 0 pressure INST button is sparked, Shouldn't be constant.