The Powder Toy

THRM Power Plant (Functional by HowlsChaos

HowlsChaos
HowlsChaos
85 / 12
13th Feb 2013
17th Feb 2013
A Thermite power plant. Full controls on system, and heating. Make sure Ambient Heat is OFF - before you spam that it blows up.
powerplant thrm reactor nonnuclear electronics

Comments

  • HowlsChaos
    HowlsChaos     14th Feb 2013
    Make sure ambient heat is off people. It is the ONLY reason why it would malfunction.
  • Kraken_078
    Kraken_078     14th Feb 2013
    Very good
  • phoenixsilverbird
    phoenixsilverbird     14th Feb 2013
    It just blows up.
  • monolith
    monolith     14th Feb 2013
    awesome!!!!
  • HowlsChaos
    HowlsChaos     14th Feb 2013
    +1 Ironpenguin
  • shon23lolz
    shon23lolz     14th Feb 2013
    Nice thanks
  • powderyperson127
    powderyperson127     14th Feb 2013
    Shut up, spammer.
  • eman123
    eman123     14th Feb 2013
    when i did it, it went boom!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
  • fuzzybug123
    fuzzybug123     14th Feb 2013
    That helps. I just didn't know if u were supposed to do it in a certian order.
  • Ironpenguin
    Ironpenguin     14th Feb 2013
    Its not that hard to figure out. if you need a guide, here you go. Turn on the thermite pump and glow pump. turn on the heat transfers and cooling, hit fill and when the tanks are sufficiently filled, you hit ignite. later you hit drain. rinse and repeat the fill/ignite/drain cycle, boom.