The Powder Toy

Super Fast Copy Machine by benthecrazy

benthecrazy
benthecrazy
175 / 7
21st Feb 2013
26th Nov 2013
This is the fastest copy machine on TPT! It runs at a speed of 2 frames per line which is 4 times faster than any other copy mechanism which currently runs at 8 frames per line.
crazyfast piston fastestever myfaceonfire superfast fast fastest electronics electronic

Comments

  • ajcharger24
    ajcharger24     24th Feb 2013
    WWWOOOOWWWW EPPPPIIIIICCCC!!!!!
  • benthecrazy
    benthecrazy     24th Feb 2013
    Done, there you go ;)
  • benthecrazy
    benthecrazy     24th Feb 2013
    You shouldn't cancel until the bottom piston thingy is at its lowest position. I'll build a little safety mechanism so that you can't cancel unless it's in the lowest position.
  • phoenixsilverbird
    phoenixsilverbird     24th Feb 2013
    Can you make it possible so you can copy, then cancel, then copy again etc. because when I try to use it more than once, it malfunctions and blows up.
  • benthecrazy
    benthecrazy     24th Feb 2013
    I found the cause for the deco bug. I had to insulate the device printing the copy with additional cray because after clearing the print the device gets so cold it triggers the C-5 of the next print. I just had to put some filt between the creating and the insulating cray.
  • AC
    AC     24th Feb 2013
    GOTTA GO FAST +1
  • Pilihp64
    Pilihp64     24th Feb 2013
    @oldmud0, it doesn't miss any lines, the only thing odd is that the result is missing a few lines of decoration, it still copies perfectly.
  • oldmud0
    oldmud0     24th Feb 2013
    I find this new method a bit less reliable because, although I like the scan line look, it skips over a line a few times.
  • benthecrazy
    benthecrazy     24th Feb 2013
    Great speed improvement! Runs now at 2 frames per line thanks to cracker64 for outstanding help!
  • combustion-man
    combustion-man     24th Feb 2013
    super fast being an understatment...