Witness the life and death of a P.T. star with this little fusion chamber. Stars will slightly differ every replay. Last 2-4 min. This was so fun to make. Enjoy! Credit goes to Alfa(id:1683916) and Alexzander(id:1689167) for inpiration of chamber design.
fusion
cycle
star
heat
life
chamber
realistic
nuclear
power
reactor
Comments
-
@jakkers7, the first bright white flash is part of phase 1. The supernova shoudn't happen until after several minutes. I've tested this enough times to fine-tune for consistency. Hope you enjoy now that I've clarified! ^ _ ^
-
mine supernovaed after i unpaused no lie just boom den no thing left
-
My star skipped to stage three then went supernova
-
super novaaaaa!!!
-
The way i found may fail and lead to stage 6.
-
I found you can restart it from stage 2 or 3 after it dies by removing the black hole and just spamming protons.
-
I think did too by putting a bit of co2 in it
-
I watched it go super nova
-
I reloaded the simulation, the star skipped stage 1 compleatly and like grisha5 mine hiccuped then died
-
OK mine did the weirdist thing, it went into stage 6 did the first flash of white light then decided to be a rebel and became a mini stage 4 star for a good 15 seconds then it turned into a black hole and note it went down the line of stages with no repetition.