The Powder Toy

Water Purfier V2 by Drizziie

Drizziie
Drizziie
42 / 8
2nd Jul 2015
6th Jul 2015
No Description provided.
wall simple water boiler heater distilled salt glow

Comments

  • Drizziie
    Drizziie     6th Jul 2015
    @Sourec I think it's good now. Once it gets heated up it doesn't stick as much :D
  • Drizziie
    Drizziie     6th Jul 2015
    @DEstratus Never thought of that! Good idea.
  • destratus
    destratus     6th Jul 2015
    in my purifier i used WALL to cool the water i made it into a 2x2 square and it cooled it super fast
  • Sourec
    Sourec     6th Jul 2015
    @Drizziie if any of the glow gets stuck, you can cap off of the top of the glow chambers and put some positive-temp pump in there. It'll create a little bit of a wind tunnel effect with pressure escaping through the aironly walls at the bottom, which should be enough to push the GLOW through.
  • Drizziie
    Drizziie     6th Jul 2015
    @Sourec I never though of using NTCT or PTCT for cooling lol I tried using the checkardboard pattern but some of the GLOW would get stuck :( Probably due to high pressure maybe?? I'll work on an update to it xD Thansk!
  • Sourec
    Sourec     5th Jul 2015
    @Drizziie I tried it; the GLOW does get hot, but not hot enough to melt the cooling system. Furthermore, if desired you can simply replace with PSCN cooling system with a more efficient NTCT or PTCT cooling system.
  • destratus
    destratus     5th Jul 2015
    just because of this im going to remake that machine and bio engineer a cybernetic organism that does the same thing as this
  • destratus
    destratus     5th Jul 2015
    i made somthing exactly like this 5 days ago and didnt think i should post it and today i thought i would but then i see this! i worked for a night making it so complicated its sure to get FP but then i see this! i wouldnt of thought of using glow to heat the saltwater thought
  • Drizziie
    Drizziie     5th Jul 2015
    I see what you mean, but it keeps the temp of the glow down so the water isnt blazing hot; which could make it melt the cooling system. But i know its not very effecient at all lol
  • Sourec
    Sourec     5th Jul 2015
    I like it, but it's inefficient. You need to put an offset grid of FILT (so the FILT looks like a checkerboard) in those two heat transfer units in the burner. Right now, only GLOW near the fire gets the heat; using an offset FILT grid transfers the heat far more evenly (I tested it with my own version!).