WiFi

Wireless transmitter, transfers spark to any other wifi on the same temperature channel.
Properties
Section	Electronics
Spawn temperature	22°C
Heat Conductivity	0%
Relative weight	100
Gravity	0
Acid dissolve rate	0.2%
Flammability	0
State	Solid
Transitions
High pressure	above 15 pressure
Source code

Usage

There are 101 "channels" available to WiFi. A WiFi particle's channel is determined by its temperature. The first channel ranges from 0 to 73.15°K (-273.15 to -200°C), and after each channel is 100° apart, so that the next channel is 73.15 to 173.15°K (-200 to -100°C), and so on.

The easiest way to set the channel is to use PROP. Change the WIFI's temperature to the channel, multiplied by 100. For example, to get channel 47, you would set the temp to 4700. The actual channel is shown in .tmp, to make it easier to see.

When a particle of WiFi is sparked by any material except NSCN, all WIFIs on that channel will output SPRK to any PSCN, NSCN and INWR that are touching the wifi (including diagonally).

Reactions

WiFi does not conduct heat, but its temp can be changed by PROT.

EMP will randomly change the temperature of WIFI that is being sparked.

When the pressure of WIFI is above 15, WiFi will break into BRMT, which will immediately melt if the channel was above 10 (1000°C)