The Powder Toy

4 Bytes of PROGRAMMABLE ram! + lcd by JF58

JF58
JF58
2 / 2
1st Dec 2017
1st Dec 2017
Finnaly in use. Kind of complicated and not space efficent but good nonetheless. To code a number: first lcd = first 7 aray on the bottom the ones pointing up. 1st aray is the top lcd, 2nd is the left most on the upper half and the 3rd is the right most.

Comments

  • Terortemper
    Terortemper     18th Mar 2023
    TehBoxtrot94: kid
  • TehBoxtrot94
    TehBoxtrot94     27th Mar 2018
    no u -1
  • JF58
    JF58     1st Dec 2017
    sorry for the instructions being so long :( and sorry for being so confusing, ill make improvments soon
  • JF58
    JF58     1st Dec 2017
    and last is, near the read switch is a tiny button (only 2 pixles) is the clear lcd
  • JF58
    JF58     1st Dec 2017
    the long thin line protruding from the place where you clear mem is the read switch this will display to lcd
  • JF58
    JF58     1st Dec 2017
    the big rectangle on both bottom and top is clear memory.
  • JF58
    JF58     1st Dec 2017
    to trigger do the display and clear mem/ clear lcd is as follows
  • JF58
    JF58     1st Dec 2017
    then the ones after the insl on the top are for the 4th lcd, again same config
  • JF58
    JF58     1st Dec 2017
    It gets complicated here because the last 2 on the bottom are the first for the 3rd lcd, theres 2 on the bottom and 5 on the top near the lcd. same config for these
  • JF58
    JF58     1st Dec 2017
    The second set of 7 is between the insl, these are the same and control the 2nd lcd.