Energy sword by Omen4stako
I used Madscientist226's Energy Sword mold to get the correct shape. I did smoothen out the grip tho because i thought it was a bit too blocky. The electronics are fully made by me.
halo
energy
sword
neutron
plasma
electronics
Comments
-
TeslaThePlasmaUser 25th Jun 2022
awsome halo stuff +1 -
Omen4stako 4th Aug 2021
I think thats all. I hope you enjoy the save. -
Omen4stako 4th Aug 2021If you have another reason to downv0te other than these two reasons, go ahead and downv0te so i will know if the save is good or not. If you still think these two reasons are good reasons to downv0te for, then go ahead and downv0te. Atleast try to be fair when voting my saves and everyones saves in general, thank you.
-
Omen4stako 4th Aug 2021Also i have noticed that people tend to downv0te saves where im crediting someone for a part i used in the save. When you downv0te, make sure its not because i used someones save when making this. The owner of the save literally allows people to use the mold. It would have been 10 times harder to make this save without knowing the shape of the blade. Try to recreate this save without using the mold and you'll see why its so hard to make the blade look like the blade in the energy sword in Halo.
-
Omen4stako 4th Aug 2021If you dont like it, tell me how to improve it. I know a lot of new players have joined tpt lately and use mobile to play it, so if you play on mobile its not my fault that the blade looks bad. It looks bad for you because you have low fps. If you find another issue with it other than the blade looking bad beause of low fps then go ahead and tell me because i want this energy sword to be as good as possible.