The Powder Toy

Anmol444

My best laser so far!

Watch in nothing display.

The-Con

@Anmol444 (View Post)
The PSCN and NSCN melt fast, that impairs the ability to turn it on/off easily.
Photons leak out of the sides.
The red colour allows too many photons to rebound and create an unclean cut.
I've seen other lasers from you and I'm sure you know that the blue colour is the best for performance.

Edited by The-Con, 2011-06-15 13:45:51

dion66

awesome

Anmol444

@The-Con (View Post)
It is cause of the new release I think.

CAC-Boomerang

@Anmol444

I once made a laser using WALL, and when the photons rebounded off the target, it always seemed to heat the NSCN and PSCN quickly.

A rough, inaccurate way to solve this is to attach a few 2x2 squares of HLIF around the PSCN and NSCN.

Anmol444

@CAC-Boomerang (View Post)
To fix that problem put a pixel of inst in front of the laser. Make sure that the phot goes through the inst. Then when it bounces back it won't reach the Pscn/Nscn

Example:

335073View Save 335073

The big Neut and Phot Laser.

@The-Con (View Post)
I fixed everything.

Edited by Anmol444, 2011-06-16 04:29:13

Awesome Laser